On a mobile device?

View the LSU Libraries Mobile Website at
http://www.lib.lsu.edu/m/

Collection Services - Serial Services:
SE-LIN Plus II Electronic Label Laminator

Diagram of Laminator | Getting Started | Loading the SE-LIN Label Roll | Loading the Clear Overlay Tape | Taking Care of your SE-LIN Plus II Electronic Label Laminator

Back to Serial Services Home

• Getting Started

  1. Attach laminator to baseboard.
  2. Position computer printer on top of base board as close as possible.
     Visually align tractor feeds of laminator to pull-through tractor feed of computer printer.
     Alignment of tractor feeds need not be exact. Alignment will be maintained thro ughout the labeling process.
  3. Plug laminator into power outlet.
  
  

Back to Top

• Loading the SE-LIN Label Roll

  1. Remove the base tape roller.
  2. Slide roller into core of SE-LIN label roll. Label side down, replace roller into laminator.
  3. Pull label roll lead so that label stock goes under the two aluminum spindles.
  4. Feed labels into printer through the back of the platen. Advance labels. Attach labels to pull-through tractor feed.
  5. Feed labels under laminator bail rod.
  6. Advance labels to attach to laminator tractor feed.
  7. Using the hand wheel,catch the end of the SE-LIN label lead between the two pressure rollers.
  
  

Back to Top

• Loading the Clear Overlay Tape

  1. Loosen right brass guide to allow placement of clear overlay tape into clear tape roller.
  2. Insert clear overlay tape roll on the roller so that it will unwind from the bottom, adhesive side up.
  3. Position brass guides by visually aligning inner guides with edges of SE-LIN label surface.
  4. Pull the end of the clear tape over the guide bar.
  5. Apply the adhesive side of the clear tape to the SE-LIN label surface, aligning it by eye as carefully as possible.
  6. Feed the combined label and tqape through the pressure rollers a few inches by turning the hand wheel.
  7. Turn power on. Press the Line Feed button on the computer printer several times to check the alignment of the overlay tape to the SE-LIN surface. Alignment typically improves as labels are run.
  8. View cross section of proper threading.
  
  

Back to Top

• Taking Care of your SE-LIN Plus II Electronic Label Laminator

  1. Once aligned, you will not have to alter the width adjustments on the tractor feeds and brass guides again unless you are using multiple widths of label stock.
  2. To clean, scrape adhesive away from the roller with a soft cloth and general purpose adhesive cleaner. Use adhesive cleaner sparingly to avoid spillage onto the rubber roller.
  3. The tension on the rollers should be released on a daily basis to prevent the upper roller from gradually leaving a permanent indentation on the bottom rubber roller. Loosening two to three turns should be satisfactory. Adjustment knobs can be tightened until shoulder of screw contacts casting.

Back to Top